News:

Registered a URL and setup a forum as the IPCam stuff really needed its own site vs my irregular blog posts about IPCam hacking at http://www.computersolutions.cn/blog

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jjrowan

Pages: [1]
1
Firmware / Wanscam WiFi problem
« on: October 26, 2019, 06:06:10 pm »
I have a Wanscam with default Device ID of 002blve running firmware version 21.22.2.27 and Web UI version 0.7.4.2.  When I try scanning WiFi for access points the list appears for a fraction of a second then goes blank.  I've tried Firefox, Chrome and Internet Explore, same happens with each browser.  If I connect the camera via Ethernet and put it in my garage the WiFi problem prevents the remote control for the garage door openers from functioning.  Power the camera off and remote for garage door works fine.  I have reset the camera to factory defaults but still has same problem.  I was hoping there was a new firmware available I could apply to resolve the two problems.

Pages: [1]