News:

Registered a URL and setup a forum as the IPCam stuff really needed its own site vs my irregular blog posts about IPCam hacking at http://www.computersolutions.cn/blog

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ayagle

Pages: [1]
1
General Discussion / wanscam jw0008
« on: February 20, 2016, 08:26:55 pm »
Hello, has anyone been able to flash any firmware to this device?.. I have some firmware that matches in numbering, but quite a bit off from what is loaded, however, when I flash the ui it simply reboots.. I did see the earlier post regarding an issue like that..      the board is different from other foscam clones I have seen, it seems that the wireless and the main chip might be together on a riser board.  v. 2a on the board I believe     

having trouble with ftp and alarm, so any help appreciated..          thanks

**update, I did actually get the firmware to flash, but unfortunately the firmware was for jw0004, it would seem that camera might have a different camera sensor or some thing along those lines, because now I don't get any picture.. not bricked, it seems to work, but the green light flashes and no image..     

any help greatly appreciated.. wanscam isn't being helpful or responding at all for that matter..

2
Hacking & Modding / iprobot3 camera board/module?
« on: July 19, 2015, 04:34:22 pm »
Hello, is it possible to use the camera board separately through usb or a ardiuno ?..  anyone know the pinout on the red and black connectors used by some clones in the 2014 versions?     

The reason I ask is because my veevo (I believe it was) fell and landed pretty hard, after that the ethernet port quit working and I haven't been able to get anything to come up with a tty-usb on j9? i think it is.. (under the chip)   so I would like to salvage something other than the motors and wifi from the camera..

Thanks for any input..

3
Similar Hardware / testing camera daughter board?
« on: June 18, 2014, 09:54:00 am »
Is it possible?...  I'm wanting to hook it up through usb to the computer to see if it does indeed work.. or replace the main board with an adriuno or something like that.      any input?.. 

It is of course from an easyn fm-166 the cam bard is labeled ov7740 1-24-2013 easyn 1.0


thanks

4
Firmware / Need help finding the correct firmware
« on: June 16, 2014, 03:11:04 pm »
I have an easyN IP cam, the box is labeled F-M166 all the firmware I have tried to flash it with fails to load the camera. I have taken it apart and the camera board is labeled estespcb67740xxx1y and the chip is v366 are these different than most models of foscam clones?.. or is it possible that something has gone wrong with the connection from it to the main pcb?..           Thank you in advance for any assistance that anyone can give..

5
Similar Hardware / model easyN fs-613b-m166 (b613m136xa pcb)
« on: June 08, 2014, 09:09:15 pm »
I was a little preoccupied when I tried to change the firmware on it.. I was trying to fix the color, it was extremely awful.    I will try to post a picture of the board.. it doesn't have the typical j2 pin locations.. :/      any help extremely appreciated..     

*edit, I removed links to personal server, only the google link below is still valid

Pages: [1]