Did you know - OpenIPCam has an Extensive files section of firmware, utilities and developer tools -

Author Topic: Firmware Recovery - method #2  (Read 112011 times)

  • No avatar
  • *
October 14, 2015, 04:11:13 pm
Does anyone know the pin out for a F19810 Also can you use hyperterminal I here the free version doesn't work well
I'm just transferring a good firmware from a good cam and put it in the bad one if everything goes well I have read and read a little help would be appreciated don't want 2 dead cams I have ordered a PL-2303TA USB Download Cable

« Last Edit: October 14, 2015, 04:15:40 pm by it_aint »

  • No avatar
  • *
December 06, 2015, 04:17:14 pm

I am looking for the pinout for FI9816P PCB

I tried to locate where is the TX/RX but Nothing is written on the PCB  :-[

Does anyone know about this board ?

Thanks for your help
« Last Edit: December 13, 2015, 04:50:35 am by cyril4u »