News:

Registered a URL and setup a forum as the IPCam stuff really needed its own site vs my irregular blog posts about IPCam hacking at http://www.computersolutions.cn/blog

Author Topic: HELP NEEDED  (Read 4602 times)

  • No avatar
  • *
July 06, 2014, 02:49:22 pm
Hi ,
I had a ip camera . long ago i tried to upgrade my firmware to foscam firmware , but in the middle my power went off and the upgrading process got stucked in the middle. Now whenever i start my IP camera through IPCAM tool ,the ip address is shown for just 3 seconds and again it goes blank and rebooted. i am not able to Repair it through IPCAM REPAIR tool as both Router and CAMERA  was configured in the address 192.168.10.2 and 192.168.10.3 respectively. I can't even remember my username and password to access it through CUTEFTP . moreever my RESET button is also not working . PLEASE any body help me .......

  • No avatar
  • *****
July 08, 2014, 04:14:55 am
I had a crystal ball and was able to tell the future long ago ......