News:

Registered a URL and setup a forum as the IPCam stuff really needed its own site vs my irregular blog posts about IPCam hacking at http://www.computersolutions.cn/blog

Author Topic: Connected users / Active sessions  (Read 3685 times)

May 30, 2013, 05:24:11 am
Hi,

Is it possible to know who is connected without looking at LOG (because it doesn't say when the last user disconnected)?
My idea is to see if there are any active sessions, send "set_misc.cgi&led_mode=1" command to turn LED on (so that I can know if someone is connected) and when the session is finished, send "set_misc.cgi&led_mode=2" to turn the LED off.

If there is any variable or flag that let you know that, than it would be very easy to write a simple code to read this flag and update the LED. This could be done outside or even integrate this option in custom firmware. :D

Thanks
« Last Edit: May 30, 2013, 05:26:25 am by 3dK »