Registered a URL and setup a forum as the IPCam stuff really needed its own site vs my irregular blog posts about IPCam hacking at

Author Topic: how to set a hard drive to over write  (Read 5057 times)

  • No avatar
  • *
May 30, 2019, 12:01:49 pm
i have an nvr model nvr6208 i installed a 500gb hard drive for 3 cameras i have some options
format storage,recover,partition,read/write,redundant,read only. what is happening is it get full and then a window pops up to tell me the hard drive needs attention. what i would like is to get it to just overwrite. i have a zmodo dvr and that one over writes but this one seems to fill up and stop recording.

i know what most of these do but what is the recover and redundant for what do they do. and what setting would i look for to have the nvr just overwrite? thanks