News:

Registered a URL and setup a forum as the IPCam stuff really needed its own site vs my irregular blog posts about IPCam hacking at http://www.computersolutions.cn/blog

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - novasat

Pages: [1]
1
Firmware / Maygion mips MJPEG ipcam MAC address
« on: March 22, 2016, 10:15:17 am »
2 Maygion mips MJPEG   ipcam with the same MAC address
I need to know where MAC address is located and how can we change it?


2
Help / Two MAYGION mips MJPEG ipcam with the same MAC address
« on: March 10, 2016, 10:08:27 am »
2 Maygion mips MJPEG   ipcam with the same MAC address
I need to know where MAC address is located and how can we change it?

3
Firmware / Help needed, my new IP Cam MP-3.3 with WPS is dead
« on: May 13, 2012, 08:39:41 am »

press for a large picture


press for a large picture


press for a large picture

Hello ALL
Only after a week the camera was not responding or some times yes and many times no .
Normally when you press the WPS button you got a blue led at the back near the wps switch that fliker until you have a connection with the router then it turn off.
Before camera died the wps button was not responding.

After that the camera went  hot. I open it and I found the horizontal stepper motor and the power driver IC ULN2803 at the bottom of the camera very hot.
I remove the motor socket and the ic ULN2803 cool down with the main power on.
I think the main problem is with firmware.

I bought another camera and in less than a week the same scenario happen again.
What I was sure of is that the camera was connecting on IP 192.168.1.111 but now the router is not seeing the camera.
I tried FTP but no luck.
If any one can help with this hardware MP-3.3 , this will be great.
Thanks

Pages: [1]