News:

Re-organized the forum to more cleanly delineate the development section, as the end user support side appears to have taken a life of its own!

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - winek0

Pages: [1]
1
Firmware / Hi 3518E BLK18E-0012 50h10PE-WP Firmware
« on: July 09, 2017, 04:00:13 am »
Hi I have a problem with my camera after the update does not start looking for a firmware for it.



U-Boot 2010.06-svn (Oct 14 2015 - 15:07:23)

DRAM:  256 MiB
Check spi flash controller v350... Found
Spi(cs1) ID: 0xC2 0x20 0x17 0xC2 0x20 0x17
Spi(cs1): Block:64KB Chip:8MB Name:"MX25L6406E"
envcrc 0xd2097268
ENV_SIZE = 0xfffc
In:    serial
Out:   serial
Err:   serial
Press Ctrl+C to stop autoboot
CFG_BOOT_ADDR:0x58040000
8192 KiB hi_sfc at 0:0 is now current device

### boot load complete: 1973968 bytes loaded to 0x82000000
### SAVE TO 80008000 !
## Booting kernel from Legacy Image at 82000000 ...
   Image Name:   linux
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    1973904 Bytes = 1.9 MiB
   Load Address: 80008000
   Entry Point:  80008000


load=0x80008000,_bss_end=80829828,image_end=801e9e90,boot_sp=807c7168
   Loading Kernel Image ... OK
OK

Starting kernel ...

Uncompressing Linux... done, booting the kernel.




Pages: [1]