News:

Registered a URL and setup a forum as the IPCam stuff really needed its own site vs my irregular blog posts about IPCam hacking at http://www.computersolutions.cn/blog

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - LexaMan

Pages: [1]
1
Firmware / Re: Firmware Wansview ncs601w
« on: December 04, 2017, 01:32:06 pm »
Who fumbles in the openwrt fillings on the ip camera? Camera wansview ncs601w nadybal that type filled her openwrt http://www.wanda25.de/wansview_ncs601w.html , but it is impossible to do everything. I disassembled it, soldered contacts to the UART, the programming file filled openwrt-ramips-rt305x-ncs601W-initramfs-uImage.bin using tfttp and putty, but I can not fill in the second file openwrt-ramips-rt305x-ncs601W-squashfs-sysupgrade.bin and how to fill it I do not quite understand. Type it is written that through the web interface it is not filled because It does not work yet, and through sysupgrade too .... I used wincsp to fill it in the memory of the camera in the / tmp folder and in ssh I made the command that is written according to the instructions, like something went wrong, but then silence and like nothing did not. After the camera is restarted, this sysupgrade file disappears from the / tmp folder. Can someone tell me how to fill this file in order to move on in the instructions ?! P.S. By ip 192.168.1.1, the camera interface does not enter.

2
Firmware / Firmware Wansview ncs601w
« on: December 03, 2017, 08:15:45 am »
Can you please tell how to flash openwrt on ip camera WansView NCS601W. I have a programmer CH341A with UART.
I read that a man has pierced the camera on openwrt and it has become an ordinary ip camera. I dismantled it, connected UART, but what program to use to fill the firmware openwrt I do not know. The firmware consists of two files .bin

Pages: [1]