Registered a URL and setup a forum as the IPCam stuff really needed its own site vs my irregular blog posts about IPCam hacking at

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - xdj.pcm

Pages: [1]
Firmware / Re: XMeye Hi3518E-based camera module
« on: October 31, 2016, 07:51:34 am »
Spi id table Version 1.22
Hisilicon Spi Flash Controller V350 Device Driver, Version 1.10
Spi(cs1) ID: 0xC2 0x20 0x17 0xC2 0x20 0x17
SPI FLASH start_up_mode is 3 Bytes
spi size: 0x8388608
chip num: 1
6 cmdlinepart partitions found on MTD device hi_sfc
Creating 6 MTD partitions on "hi_sfc":
0x000000000000-0x000000040000 : "boot"
0x000000040000-0x0000003b0000 : "romfs"
0x0000003b0000-0x000000630000 : "user"
0x000000630000-0x000000770000 : "web"
0x000000770000-0x0000007b0000 : "custom"
0x0000007b0000-0x000000800000 : "mtd"

Hello, please have someone file the first contribution.
I contacted the author, but unfortunately I was not successful.
Please, please, thank you very much.


Hacking & Modding / Firmware raw dump HI3518E flash 8Mb
« on: October 14, 2016, 02:01:51 am »
Please someone recorded a raw dump this camera.
Flash - MX25L6406E - 8Mb
Processor - HI3518E
Camera images are included.
First I made a backup camera with the programmer, -->
I tried to flash General_HZXM_IPC_HI3518E_50H10L_S38_V4.02.R12.Nat.OnvifS.20160615_ALL_.bin but without success.
It leads me to this step the fact that it does not permanently change the IP address of the camera is not set, it is merely run stream SD or HD. Can not change the password to the camera, which is bad enough, the camera is connected to the Internet.
Thank you for your support and I apologize for English.

Pages: [1]