News:

Registered a URL and setup a forum as the IPCam stuff really needed its own site vs my irregular blog posts about IPCam hacking at http://www.computersolutions.cn/blog

Author Topic: model easyN fs-613b-m166 (b613m136xa pcb)  (Read 10343 times)

  • No avatar
  • *
June 20, 2014, 08:47:15 pm
 :-\      it's apparently e-waste at this point.. thanks again for the help schufti

  • No avatar
  • *****
June 21, 2014, 07:03:44 pm
Hi,
As far as i remember the cam should get detected during kernel startup, right after usb initialization and loading ip stack. Some time ago easyn had a webpage offering fw for download. I don't know what they are up to now. Some time ago someone (graham?) mentioned they are referring to foscam for downloads nowadays...
Did they at least ack the cam is their product?
 

  • No avatar
  • *
June 21, 2014, 08:25:22 pm
They didn't say much really, just that they couldn't help me with it.

I did mention that I needed to load it via serial though.. I also have written back and requested a full firmware package. no response yet..       ???