Registered a URL and setup a forum as the IPCam stuff really needed its own site vs my irregular blog posts about IPCam hacking at

Author Topic: Need help finding the correct firmware  (Read 5413 times)

  • No avatar
  • *
June 16, 2014, 03:11:04 pm
I have an easyN IP cam, the box is labeled F-M166 all the firmware I have tried to flash it with fails to load the camera. I have taken it apart and the camera board is labeled estespcb67740xxx1y and the chip is v366 are these different than most models of foscam clones?.. or is it possible that something has gone wrong with the connection from it to the main pcb?..           Thank you in advance for any assistance that anyone can give..

  • No avatar
  • *
June 19, 2014, 10:16:45 pm
I finally got a response from easyN after 2 weeks...   

"sorry, as for this, i can do nothing. can you access your ipcam normally now?"               :o :(

that was their response after informing them that I used the webui to attempt to change the firmware.

    with a $40 camera, wouldn't most people try to change the firmware if it didn't work rather than ship back the camera?  especially when there is place in the ui to do so?..      idk.. just saying..   :P