News:

Re-organized the forum to more cleanly delineate the development section, as the end user support side appears to have taken a life of its own!

Author Topic: Need help with b1 series Wansview NC541W IP Camera clone  (Read 6487 times)

July 06, 2013, 07:40:48 pm
Hi.
I recently purchased 2 B1 series clones from Ebay. They both worked fine.
Then I updated the firmware on one of the cams and it is not getting an IP
assigned. How do I reset it to "Factory" condition. In other words, a hard reset.
I tried the reset button in a couple of ways, but no good.
Thank you for any help you can give me.

  • No avatar
  • *
November 23, 2013, 06:21:08 am
What brand and model did you get and what fi4mware and steps did you do to flash it?
I just got a Kaicong sip1016 from ebay.