Re-organized the forum to more cleanly delineate the development section, as the end user support side appears to have taken a life of its own!

Author Topic: Any Alternative Ways to Configure a Foscam Clone?  (Read 2477 times)

  • No avatar
  • *
June 13, 2018, 09:20:01 pm
I have a clone that I lost the software for.  I didn't realise it was unique.  But apparently it was.

Because using the software I normally connect to my Foscams with I get no configuration option on screen. From this camera.  From all the others I do of course.  But not this one.

I can connect to it using push firefox mode and I can control the pan/tilt.  But I can't change its settings.

Can anyone suggest anything that might help?  Other software perhaps more 'powerful'?

Some cmd prompt method of sending it commands?

« Last Edit: June 13, 2018, 09:21:39 pm by abrogard »

  • No avatar
  • *****
July 05, 2018, 03:33:12 pm
connect directly to the webui of the camera on its ip address?