News:

Registered a URL and setup a forum as the IPCam stuff really needed its own site vs my irregular blog posts about IPCam hacking at http://www.computersolutions.cn/blog

Author Topic: Hi 3518E BLK18E-0012 50h10PE-WP Firmware  (Read 908 times)

  • No avatar
  • *
July 09, 2017, 04:00:13 am
Hi I have a problem with my camera after the update does not start looking for a firmware for it.



U-Boot 2010.06-svn (Oct 14 2015 - 15:07:23)

DRAM:  256 MiB
Check spi flash controller v350... Found
Spi(cs1) ID: 0xC2 0x20 0x17 0xC2 0x20 0x17
Spi(cs1): Block:64KB Chip:8MB Name:"MX25L6406E"
envcrc 0xd2097268
ENV_SIZE = 0xfffc
In:    serial
Out:   serial
Err:   serial
Press Ctrl+C to stop autoboot
CFG_BOOT_ADDR:0x58040000
8192 KiB hi_sfc at 0:0 is now current device

### boot load complete: 1973968 bytes loaded to 0x82000000
### SAVE TO 80008000 !
## Booting kernel from Legacy Image at 82000000 ...
   Image Name:   linux
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    1973904 Bytes = 1.9 MiB
   Load Address: 80008000
   Entry Point:  80008000


load=0x80008000,_bss_end=80829828,image_end=801e9e90,boot_sp=807c7168
   Loading Kernel Image ... OK
OK

Starting kernel ...

Uncompressing Linux... done, booting the kernel.



« Last Edit: July 09, 2017, 04:04:21 am by winek0 »