I have another forum dedicate to arcade board and handheld reverse engineering over at

Author Topic: Wansview Ncm624GA brick  (Read 613 times)

  • No avatar
  • *
November 04, 2016, 07:35:21 pm
Greetings friends. I have a camera Wansview ncm624GA that after updating and it works correctly, I loaded the backup settings and has been brick. Ip does not have, does not move to restart, etc .. from the service Wansview not give me help to repair because they say that the fault has been mine..¿ anyone can help me get this camera? Either by telnet, JTAG, usb-ttl, etc ... thank you very much for everything !!
« Last Edit: November 06, 2016, 04:46:28 pm by txutxy »