News:

Registered a URL and setup a forum as the IPCam stuff really needed its own site vs my irregular blog posts about IPCam hacking at http://www.computersolutions.cn/blog

Author Topic: Wansview NCM624W and NCM625W I/O Relay Switch function  (Read 2820 times)

  • No avatar
  • *
June 19, 2015, 06:37:51 pm
Hi!
I have two Wansview NCM624W and one NCM625W and would like to use the relay on / off switch function via URL / Webgui like it was possible with the 541 but there are no chain symbols on the Webgui and the cgi url command (decoder) is not working. Is there a chance to get this to work...maybe with a compatible firmware from a similar model / made? Thanks a lot !